qbone-assy-step-4 | The Decromancer

The LEDs and their printed plastic housings.

The short leg / flat side of the LED goes towards the

Bend the leads at a right angle, against the plastic housing.

Install the LEDs and housing flush and aligned with the board.

Install the LEDs and housing flush and aligned with the board.

Here is the location of the male IDC headers for UART1, UART2, and I²C panel.

Use the centered-plastic pin header for the jumper blocks. Twist to separate.

Here is what you should have after separating the pin header into sections.

Here are the locations for all of the shunt jumper pin headers.